We recommend you read these instructions carefully before fitting your quartz clock movement.

Fitting the Movement

· Ensure the hole in the centre of the dial has a diameter of 9mm

· Fit the spindle through the dial (the hanging hook and any packing should be installed now if necessary)

· Fit the rubber washer, washer and nut and tighten firmly

Adding the hands

· Remove the plastic protection from the hands

· Push the hands firmly onto the spindle in the following order - Hour, Minute, Second

· Check from the side to ensure hands do not overlap. If hands overlap, gently bend into position

· Set the clock to the correct time using the knob on the rear of the movement

· Insert a AA battery (we recommend a new Alkaline battery)

Inserting a pendulum

· Prior to fitting the movement, gently swing the pendulum arm to the side and insert the quartz movement

· An additional AA battery is required for the pendulum

Using self-adhesive numbers

· A small weight should be applied to the numbers for at least 2 hours

Using chapter rings

· Araldite or similar glue should be used to fit chapter ring, take care not to use excess glue

· Remove the plastic protection from the face side of the chapter ring

If you are unsure about any of the steps above please Contact Us